-
Administrator
Lift Frame stuck in mount!
Well this is what I have found to be the best way to get them apart. This can be done in a driveway with basic tools. A cut off wheel and bottle jack. Fancy tools can be used as well, but many do not have them. This Lift Frame, someone cut the stops off. Of course I have stops here so I welded new ones on. You need them so you have a way to jack the Lift frame out. I should note most bottle jacks do not work horizontally, so you need the mount off the truck. It is much easier to work with off the truck as well. In the past, I have cut a slit in the receiver tube of the mount, and then used a torch to heat the receiver, but I am not sure if it helped or not. That one was a real PITA to get out. That is why on this one, I cut a section out of the first receiver tube. When I found it was not as rusted as I expected, I just cut a slit in the other one. Which turned out to be rusted more, but the 20 ton bottle jack did not care
Started like this:
IMG_2630.jpg
Never saw a pin rusted so thin in the middle before. This Lift frame must have NEVER been taken off.
IMG_2631.jpg
Cut section out of receiver tube (it can be welded back in later if you need to save the mount).
IMG_2632.jpg
Big Red and a piece of 3/4" plate scrap to act as a shim.
IMG_2633.jpg
Starting to come out. Moved 1/4" out, then move to the other side...
IMG_2634.jpg
Continued....
~Admin
Last edited by admin; 01-05-2017 at 01:11 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules