Results 1 to 2 of 2

Thread: Diamond Pull-Away Mounting Cartons

  1. #1
    Administrator admin's Avatar
    Join Date
    May 2015
    Location
    Working on a Meyer Plow in NJ
    Posts
    160

    Diamond Pull-Away Mounting Cartons

    Diamond was a trip edge plow company located in Damariscotta, Maine. Meyer purchased Diamond in 1990. In 1991 Diamond plows used the "EZ Pull-Away" mounting system. It was the Diamond version of the EZ Classic designed by Meyer. It too had receiver tubes for the Lift Frame to slide into. Unlike the Meyer EZ Classic, it utilized the H Model of hydraulic units. So while the Lift Frame looked the same as the EZ Classic, the spacing of the bottom cross tube where the pump mounted is lower (2") to accept the H Model hydraulic units (E-47H, E-57H, E-60H). It also had a Lift Arm to accept two Lift Chains, unlike the EZ Classic single Lift Chain. The Lights, hydraulic units, controllers and wiring were all Meyer, even though the hydraulic units had a Diamond decal on them. As of 2014 Meyer has fully absorbed Diamond, and now Meyer plows with bottom trip are called Diamond Edge plows.

    -Admin
    Attached Images Attached Images

  2. #2
    Administrator admin's Avatar
    Join Date
    May 2015
    Location
    Working on a Meyer Plow in NJ
    Posts
    160
    The Pull-Away is obsolete and no longer available from Meyer.

    ~Admin

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •