Results 1 to 1 of 1

Thread: Drive Pro Example

  1. #1
    Administrator admin's Avatar
    Join Date
    May 2015
    Location
    Working on a Meyer Plow in NJ
    Posts
    160

    Drive Pro Example

    The Drive Pro came out in 2007. It replaced the EZ Classic TM Series. It is a downsized version of the EZ Plus Mounting System. It utilized the E-58H hydraulic unit up until 2014 when the E-72 became standard. It is available in 6' and 6'-8" widths. Originally it was also offered in a 7'-6" width, replacing the ST, and using the EZ Plus Mounting System, making it technically an EZ Plus Mount plow, not a Drive Pro. In 2014 Meyer renamed the Drive Pro 7'-6" the "Lot Pro LD". In 2012 Meyer did come out with a 7'-6" Moldboard that fits the Drive Pro 6'-8" A Frame, and they call it the Drive Pro 7'-6" Single Pull. This is because when the Drive Pro 6'-8" came out in 2007, it was available for 1/2 ton trucks that could not handle the weight of the EZ Plus plow systems. Obviously the 6'-8" Moldboards were not wide enough to cover the track width of the Fullsize trucks with the plow at full angle. With the 7'-6" Moldboard, they are. The Drive Pro utilizes the same commercial grade hydraulic unit, wiring, lights, and controller as the 8' Lot Pro plows. There is nothing downsized other than the Moldboards and PAF, and Lift Frames. Like the MDII and EZ Plus it is a modular plow in that it uses a Universal Clevis for all vehicles, and the Universal Clevis is attached to the vehicle with a vehicle specific Mounting Carton (brackets). IF you buy a used Drive Pro, be SURE to get the Universal Clevis with it.

    -Admin
    Attached Images Attached Images
    Last edited by admin; 05-09-2015 at 09:42 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •